Digital Camera User Manual

8
Lens Adjustment
Fine-adjusting focus (using buttons provided on side face)
󱐽
󱐿
NEAR FAR
SET
RESET
󱐻
Use the zoom lever of the lens to adjust the angle of view and the focus
lever of the lens to roughly focus on the subject.
󱐽
Press the SET button. (Focus adjustment screen Page 7)
The camera automatically focuses on the subject. Note that the color of the status
indicator 󱂉 “FOCUSING” turns from black to orange.
If the camera failes to focus on the subject, the FA bar 󱂈 will not operate normally
with the status indicator 󱂉 showing “ERROR”. In this case, manually adjust the
focus. (
Electronic manual)
󱐿
Press the NEAR/FAR button to adjust the focus.
Pressing the button causes the back focus position to change, which is indicated
in the FB bar gauge 󱂊.
The position changes step by step each time the button is pressed and
continuously at a high speed when the button is held down.
If you want to restore the default back focus position in re-
adjustment, etc., press the NEAR and FAR buttons simultaneously.
While the camera is initializing the back focus position, the status
indicator 󱂉 shows “INITIALIZING”.
󱑁
Press the SET button for 2 seconds or more.
The focus adjustment screen will close and the SELECT MENU screen reappears.
The focus adjustment screen will also close automatically if left idle
for 5 minutes or more.
VCC-HD2500P/HD2500/HD2300P/HD2300:
Adjust the focus using the following procedure when the camera
fails to focus on the subject in color or black-and-white mode.
① Select [FOCUS ASSIST] on the CAMERA SETTINGS screen and
make sure that “AUTO” is set for [COLOR/B/W].
② Adjust the focus in color or black-and-white mode.
•
•
■
L5DB2_HD2500P_SM_GB.indd Sec1:8L5DB2_HD2500P_SM_GB.indd Sec1:8 2009/09/08 20:45:352009/09/08 20:45:35