ENGLISH Model Nos.: Nos. de Modelo: Nos de modèle : DP26648 DP32648 LCD HDTV Owner’s Manual Table of Contents . . . . 4 ESPAÑOL TV de LCD HDTV Manual de Instrucciones Contenido . . . . . . . . . 22 FRANÇAIS TVHD ACL Manuel d’instructions Table des matières . . 39 Welcome to the World of Sanyo Need assistance? Visit our Web site at www.sanyoctv.com Thank you for purchasing this Sanyo LCD High-Definition Digital Television.
CAUTION THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS UNIT.
FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . 2 FCC INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 TRADEMARKS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 PROTECTING THE LCD SCREEN . . . . . . . . . . . . . . . . . . . . . .3 PRECAUTIONS— Handling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION GETTING STARTED POSITIONING THE LCD HDTV Always use a firm-flat surface when positioning your HDTV. Do not position the unit in a confined area. Allow adequate space for proper ventilation. Install supplied batteries in the Remote. (2 ”AAA” eneloop Ni-MH rechargeable batteries) 1 PRECAUTIONS Do not use rechargeables together with dry cells, other types, mixed new and old, or batteries with different charge levels. Do not expose the Remote or batteries to moisture or heat.
GETTING STARTED—CONTROLS AND JACKS RIGHT-SIDE PANEL Power key Volume – + keys Channel keys 6 S-Video Input (VIDEO1), PAGE 8—To enhance video detail use the S-Video jack instead of the Video jack, if available on your external equipment. (An S-Video connection will override a connection to the Video1 input jack.
Shape Key—Press to choose between PIX options Pix1 ~ Pix4. Available options depend on the signal and the broadcast’s aspect ratio. Key—Press to select the source to Input view: Analog RF, Digital RF, Video 1, Video 2, Video 3, HDMI 1, HDMI 2, or PC Input. Key—Press to display Channel Banner Info information. Digital Antenna Banner may contain: Tuner ID, Channel Number, Station ID, Program Rating, Signal Strength, Detailed Program Info, Audio Information, & Program Title.
GETTING STARTED—CONNECTIONS 3 Analog Signal Connections— Video1 (optional) 4 Connect an analog device, such as, an Analog Cable Box, Satellite Receiver, or VCR Composite connectors are included on your new HDTV to provide continued compatibility with older analog devices, such as a VCR. The S-Video connector will provide the best analog resolution. If you have an S-Video connector on your old analog equipment, you should use it instead of the standard video connector. (Cables are not supplied.) 1.
GETTING STARTED—POWER CONNECTION / CHANNEL SEARCH POWER CONNECTION 5 6 Plug in AC power cord (120V AC, 60 Hz). Press the POWER key. (Follow the on-screen instructions.) To 120V AC outlet. INITIAL CHANNEL SEARCH 7 Press the CHANNEL (Up) key to search for signals connected to the Antenna terminal. Channel Search will check for Antenna and Cable signals. If Antenna signals are detected, the HDTV searches for both analog and digital off-air channels.
ADVANCED AV CONNECTIONS ADVANCED DIGITAL SIGNAL CONNECTIONS—HDMI TO HDMI Connect compatible Digital devices, such as, an HD Cable Box, HD Satellite Receiver, DVD Player, and Game System HDMI—High-Definition Multimedia Interface. An all digital AV interface that accepts uncompressed video signals for the very best picture possible. It supports HDCP copy protection, allowing transmission of copy-protected digital content. The signal can also include Dolby® Digital or PCM audio, when available.
PC CONNECTIONS NOTE: Before connecting any cables, disconnect the AC Power Cords of both the HDTV and Personal Computer from the AC outlets. 1 Connect an RGB cable from the monitor output on your PC to the RGB connector on the HDTV and tighten the screws. (Monitor Cable not supplied.) 2 Insert one end of a Stereo Mini-Audio cable into the PC Audio Out jack and the other end into the HDTV PC Audio Input jack. (Stereo Mini-Audio Cable not supplied.
ON-SCREEN MENU OPERATION MENU NAVIGATION MAP MANUAL CHANNEL SEARCH MAIN MENU MANUAL CHANNEL SEARCH HAS THREE CATEGORIES SUB-MENU OPTIONS • Cable • Air (Antenna) • Digital Add-On Cable Search looks for analog cable channels and unscrambled (ClearQAM) digital cable channels. This search may take several minutes. After the search is complete, the HDTV will tune to the lowest ClearQAM channel, if available. Otherwise, the HDTV will tune to the lowest analog cable channel.
CHANNEL SCAN MEMORY Channel Scan Memory is a database of active channels you scan through using the CHANNEL keys. Customize it by deleting or adding channels. 1 2 Press the MENU key on the remote control to display the Main menu. (See page 7.) Use the CURSOR keys to highlight Chanel Scan Memory. Press ENTER. ADDING CHANNELS 3 TO SCAN MEMORY DELETING CHANNELS 3 FROM SCAN MEMORY Use the CHANNEL or NUMBER keys to select the channel you want to Delete.
ON-SCREEN MENU OPERATION (CONTINUED) V-GUIDE (PARENTAL CONTROL) NOTE: THIS FEATURE IS DESIGNED TO COMPLY WITH THE UNITED STATES OF AMERICA’S FCC V-CHIP REGULATIONS. THEREFORE, IT MAY NOT FUNCTION WITH BROADCASTS THAT ORIGINATE IN OTHER COUNTRIES. 4 This Sanyo television is equipped with an electronic V-Chip to interpret MPAA (Motion Picture Association of America) and TV Parental Guidelines rating codes.
REGIONAL V-GUIDE OPERATION (ADVANCED) V-Chip Regional Ratings 5 (RRT5) is an advanced V-Chip ratings system for digital channels that are received with an antenna. Your new Sanyo HDTV supports this alternative system. 5 When the HDTV detects compatible RRT5 data, it is downloaded and stored in memory and the menu is modified to include an advanced adjustment option. The advanced rating table will reflect previous choices you may have made.
ON-SCREEN MENU OPERATION (CONTINUED) PICTURE / SOUND ADJUSTMENT ADVANCED PICTURE / SOUND ADJUSTMENTS Choose Auto to accept predetermined values for each parameter. 3 Use the CURSOR keys to select Digital Noise Reduction, Dynamic Contrast, or Loud Sound Suppressor. 4 5 Press the right CURSOR Choose Manual to adjust Picture / Sound values individually to suit your personal preferences. ADJUSTING 1 2 THE PICTURE / SOUND MANUALLY Use the CURSOR keys to highlight Picture / Sound. Press ENTER.
DIGITAL CAPTIONING ENERGY (POWER) SAVER Captioning is textual information transmitted along with the picture and sound. Turning Captioning ON causes the HDTV to open these captions (digital or analog) and superimpose them on the screen. (Local broadcasters decide which caption signals to transmit.) This power saving feature reduces the backlight brightness level. The options are: Digital Captions can be changed using the menu settings as shown. Use the CURSOR keys to highlight Digital Caption.
HELPFUL HINTS—Problems/Solutions If you are having problems with your HDTV, check this trouble shooting chart to find one or more possible solutions. Problem: Check these Conditions: No picture, sound (Digital Picture) Check antenna/external connections May be station trouble, NO signal broadcast. MUTE function may be ON. Before returning your HDTV, please visit our website at www.sanyoctv.com or call us toll free at 1.800.877.5032.
ONE-YEAR LIMITED PARTS AND LABOR WARRANTY THIS LIMITED PARTS AND LABOR WARRANTY IS VALID ONLY ON SANYO TELEVISIONS PURCHASED AND USED IN THE UNITED STATES OF AMERICA, CANADA, AND PUERTO RICO, EXCLUDING ALL OTHER U.S. TERRITORIES AND PROTECTORATES. THIS LIMITED WARRANTY APPLIES ONLY TO THE ORIGINAL RETAIL PURCHASER, AND DOES NOT APPLY TO PRODUCTS USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
