INSTRUCTION MANUAL MICRO Hi-Fi SYSTEM DC-MX30
CONTENTS PAGE IMPORTANT SAFETY INFORMATION……………………………………………………………………2 HEARING IMPORTANT NOTE……………………………………………………………………………..3 LOCATION OF CONTROLS AND FUNCTIONS………………………………………………………….4 SETTING UP AND CONNECTING THE UNIT…………………………………………………………….6 BASIC OPERATION………………………………………………………………………………………….7 RADIO OPERATION………………………………………………………...……………………………….7 COMPACT DISC OPERATION…………………………………….….……………………………………8 MP3/WMA DISC OPERATION……………………………………………………………………...………9 CASSETTE RECORDER OPERATION.……………………………………………....
IMPORTANT SAFETY INFORMATION z z z Keep this unit away from dripping or 230 - 240V 50 Hz power outlet. Using filled with liquids, such as vases, are the wrong type of power outlet might placed on or near the unit. damage the unit and even ca To completely disconnect the power use fire. z input, the mains plug of apparatus shall be disconnected from the mains. z the same or equivalent type. z direct light. Overheating will cause properly installed. z product.
CAUTION CLASS 1 LASER PRODUCT Operating the unit in a way other than specified herein, or making adjustments to the unit may result in hazardous radiation exposure You can see the label on the back of the unit LASER SAFETY This unit employs a laser. Only qualified service personnel should attempt repair. You can see this label in the CD compartment. WARNING: RISK OF INVISIBLE LASER RADIATION WHEN CD LID IS OPEN OR INTERLOCKS FALL. AVOID DIRECT EXPOSURE TO THE BEAM.
LOCATION OF CONTROLS AND FUNCTIONS MAIN UNIT 1. Power Indicator 2. REMOTE Sensor 3. BASSXPANDER Indicator 4. DISPLAY 5. FM ST Indicator 6. +VOLUME- Control 7. TUNING Control 8. Dial Pointer 9. PLAY / PAUSE Button 10. Button 11. Button 12. PROGRAM Button 13. PLAY MODE Button 14. STOP Button 15. FOLDER+ Button 16. PHONES Socket 17. AUX IN Socket 18. FUNCTION Selector (TAPE-OFF/CD/RADIO/AUX) 19. BAND Selector (AM/ FM/ FM ST) 20. BASSXPANDER 21. Cassette Door 22. PLAY Button 23. 24.
Remote Control 35. PLAY/ PAUSE Button 36. STOP Button 37. F.F. Button 38. F.R Button 39. PLAY MODE Button 40. FOLDER - Button 41. FOLDER + Button 42. PROGRAM Note: The distance between the remote control and the main unit should not be too far. The remote control should be within approx. 7 meters at straight line to the REMOTE Sensor.
SETTING UP AND CONNECTING THE UNIT Replacing battery of the remote control 1. Squeeze the notched tab A while pulling the battery door latch B out to take the battery holder out. 2. Insert a “CR2025” 3V lithium battery. Make sure the polarity (the + and – side of the battery) is correct. 3. Replace the battery holder back in the remote control. BATTERY PRECAUTIONS Follow these precautions when using battery in this device.. 1.
1. Unwind the AC Power Cord completely. 2. Insert the plug into any convenient AC outlet. 3. As soon as the unit has been connected with the mains voltage, parts of the unit are in operation due to the standby function. Turn off the unit completely before pulling the mains plug out of the AC outlet. AUX connection 1. Slide Function selector to AUX. 2. Connect a 3.5mm stereo jack lead to the AUX IN socket and the other end to your preferred device. 3. Play your device.
COMPACT DISC OPERATION Notes when operating the CD disc z Only press the CD Door Open button to open the CD door. z To remove the disc, hold it by the edges and remove from the holder. Loading Compact Disc 1. Slide the FUNCTION selector to CD position. 2. Press the OPEN button to open the CD door. 3. Place the disc into the tray with label side uppermost and push down to close the CD door. The CD player will automatically scan the disc. The total number of tracks will show in the display.
If necessary, press the PLAY/PAUSE button to begin playback. The player will randomly select a track to play from the disc. Note: In program mode, Random playback can’t be selected. Clear play mode Press the PLAY MODE button fourth times to cancel the play mode and normal playback will resume. Programmed Playback It is possible to program a selection of up to 20 tracks for playback. 1. After loading a disc, Press the PROGRAM button in stop mode. PGM and P01 will show in the display. 2.
MODE button the fourth time to active RPT RDM mode, Press the PLAY MODE button fifth times to resume the normal playback. Repeat a track Select the track to be repeated and begin playback. Press the PLAY MODE button once. The RPT indicator will show in the display and the selected track will be repeated continuously. Repeat ALBUM Select the album to be repeated and begin playback. Press the PLAY MODE button twice.
CASSETTE RECORDER OPERATION Checking the Cassette Make sure that the cassette tape has on slack before inserting it to cassette compartment. If the tape slacks, the trouble may result when you play the tape, use a pencil as shown to take up slack on one of the reels.(Refer to figure on the right.) PLAYBACK 1. Slide FUNCTION selector to TAPE-OFF. 2. Open the CASSETTE BUTTON DOOR 3. Press the button to open the cassette door.
3. Insert a blank tape with exposed side downwards and full spool to the left side into cassette compartment and close cassette door. 4. Press the 5. Press the RECORD button to start recording STOP/EJECT button to stop recording and the CD will be change to pause mode, press the RECORD button to continue recording. Press the STOP/EJECT button again to remove the cassette. Note: When the end of the tape was reached, the cassette deck will stop automatically even at playback or recording mode.
Compact Discs Maintenance z Treat the disc carefully. Handle the disc only by its edge. Never allow your fingers to contact with the shiny, unprinted side of the disc. z z Do not attach adhesive tape, stickers etc., to the disc label. Clean the disc periodically with a soft, lint-free, dry cloth. Never use detergents or adhesive cleaners to clean the disc. If necessary, use a CD cleaning kit. z If a disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
TROUBLESHOOTING GUIDE If you experience any difficulties in operating this unit, please take the time to read the hints and tips shown in the troubleshooting guide below.
SPECIFICATIONS Radio Section Frequency Range -------------------------------- AM (Built-in ferrite bar): 530 – 1600 KHz FM (wire antenna): 88 – 108 MHz CD / MP3 Player Playback System -------------------------------- Top load CD mechanism Memory Program -------------------------------- 20 Tracks Laser Output (Maximum) -----------------------Wavelength--------------------------------- 5 mW 790 土 30 nM Cassette Recorder Recording System ------------------------------- DC Bias Erase System ----------
CODE NO: 172-G401043010-OSY SANYO Electric Co., Ltd.
