User's Manual
Table Of Contents
- Sanyo Katana II User Guide
- Introduction
- Your Phone's Menu
- Getting Started
- Using Your Phone
- Phone Basics
- Controlling Your Phone's Settings
- Setting Your Phone's Security
- Controlling Your Roaming Experience
- Managing Call History
- Using Contacts
- Adding a New Contacts Entry
- Assigning a Group Entry
- Finding Contacts Entries
- Editing a Contacts Entry
- Contacts Entry Options
- Assigning Speed Dial Numbers
- Erasing a Contacts Entry From the List
- Assigning an Image to a Contacts Entry
- Assigning a Ringer Type to an Entry
- Secret Contacts Entries
- Dialing Sprint Services
- Using the Phone’s Calendar and Tools
- Using Your Phone’s Voice Services
- Using the Built-in Camera
- Using Bluetooth®
- Sprint Service Features
- Safety and Warranty Information
- Index
50 Section 2B: Controlling Your Phone’s Settings
Alert Notification
Your phone can alert you with an audible tone when you
change service areas, once a minute during a voice call,
when there are incoming messages or voicemail, or when
your network signal is fading.
To set alerts:
1. Select > Settings > Sounds > Alerts.
2. Select Service, Voicemail, Messaging, Minute Beep, or
Signal Fade and press .
3. Use your navigation key to select a setting and press .
Silence All
There may be times when you need to silence your phone
entirely. The phone’s Silence All option allows you to mute all
sounds without turning your phone off.
To activate Silence All:
©
With the phone open, press the side volume key down
repeatedly in standby mode. (The screen will display
“Silence All.”)
To deactivate Silence All:
©
With the phone open, press the side volume key up
repeatedly to select a volume level.
Tip:
You can also select
Vibrate All
to set your phone to vibrate only
(all sounds will be muted).