User's Manual
Table Of Contents
- Sanyo Katana II User Guide
- Introduction
- Your Phone's Menu
- Getting Started
- Using Your Phone
- Phone Basics
- Controlling Your Phone's Settings
- Setting Your Phone's Security
- Controlling Your Roaming Experience
- Managing Call History
- Using Contacts
- Adding a New Contacts Entry
- Assigning a Group Entry
- Finding Contacts Entries
- Editing a Contacts Entry
- Contacts Entry Options
- Assigning Speed Dial Numbers
- Erasing a Contacts Entry From the List
- Assigning an Image to a Contacts Entry
- Assigning a Ringer Type to an Entry
- Secret Contacts Entries
- Dialing Sprint Services
- Using the Phone’s Calendar and Tools
- Using Your Phone’s Voice Services
- Using the Built-in Camera
- Using Bluetooth®
- Sprint Service Features
- Safety and Warranty Information
- Index
38 Section 2A: Phone Basics
Dialing From the Contacts List
To dial directly from a Contacts entry:
1. Select >Contacts > Find/Add Entry.
2. Highlight the entry you want to call and press to dial
the entry’s default phone number.
– or –
To dial another number from the entry, highlight the
name and press , and then highlight the number you
wish to call and press .
Using Speed Dialing
With this feature, you can dial your favorite entries using one
keypress for locations 2–9. (See “Assigning Speed Dial
Numbers”on page 101.)
To use speed dial :
©
From standby mode, press and hold the appropriate key
for approximately two seconds. The display confirms
that the number has been dialed when it shows
“Connecting...”.
Note:
Speed dialing may not be available when you are roaming;
when you are roaming off the Sprint National Network, you
must always dial using 11 digits (1 + area code + number).
Shortcut:
From the standby mode, select
Contacts
(right softkey) to
display the Contacts list.