User's Manual
Table Of Contents
- Sanyo Katana II User Guide
- Introduction
- Your Phone's Menu
- Getting Started
- Using Your Phone
- Phone Basics
- Controlling Your Phone's Settings
- Setting Your Phone's Security
- Controlling Your Roaming Experience
- Managing Call History
- Using Contacts
- Adding a New Contacts Entry
- Assigning a Group Entry
- Finding Contacts Entries
- Editing a Contacts Entry
- Contacts Entry Options
- Assigning Speed Dial Numbers
- Erasing a Contacts Entry From the List
- Assigning an Image to a Contacts Entry
- Assigning a Ringer Type to an Entry
- Secret Contacts Entries
- Dialing Sprint Services
- Using the Phone’s Calendar and Tools
- Using Your Phone’s Voice Services
- Using the Built-in Camera
- Using Bluetooth®
- Sprint Service Features
- Safety and Warranty Information
- Index
30 Section 2A: Phone Basics
Ending a Call
To disconnect a call when you are finished:
©
Close the phone or press .
Changing the Ringer Volume
To change the ringer volume, use the side volume key when
the phone is open and in standby mode.
Adjusting Volume During a Conversation
When you need to adjust the receiver volume during a
conversation, use the side volume key, or press the navigation
key up or down while a call is in progress.
Note:
To change the ringer volume from the main menu, see
“Adjusting the Phone’s Volume Settings” on page 48.
Note:
If the setting for Close Flip is not set to “End,” closing the
phone will not end the call. (See “Setting the Open/Close Flip
Option” on page 67.)
END