User's Manual
Table Of Contents
- Sanyo Katana II User Guide
- Introduction
- Your Phone's Menu
- Getting Started
- Using Your Phone
- Phone Basics
- Controlling Your Phone's Settings
- Setting Your Phone's Security
- Controlling Your Roaming Experience
- Managing Call History
- Using Contacts
- Adding a New Contacts Entry
- Assigning a Group Entry
- Finding Contacts Entries
- Editing a Contacts Entry
- Contacts Entry Options
- Assigning Speed Dial Numbers
- Erasing a Contacts Entry From the List
- Assigning an Image to a Contacts Entry
- Assigning a Ringer Type to an Entry
- Secret Contacts Entries
- Dialing Sprint Services
- Using the Phone’s Calendar and Tools
- Using Your Phone’s Voice Services
- Using the Built-in Camera
- Using Bluetooth®
- Sprint Service Features
- Safety and Warranty Information
- Index
Section 2A: Phone Basics 19
Turning Your Phone On and Off
Turning Your Phone On
To turn your phone on:
©
Press .
Once your phone is on, it may display “Looking for service...,”
which indicates that your phone is searching for a signal.
When your phone finds a signal, it automatically enters
standby mode – the phone’s idle state. At this point, you are
ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically activated.
When a signal is found, your phone automatically returns to
standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also initiate a
search for Sprint service by pressing any key (when your
phone is turned on).
Turning Your Phone Off
To turn your phone off:
©
Press and hold for two seconds until you see the
powering down animation on the display screen.
Your screen remains blank while your phone is off (unless the
battery is charging).
END
Tip:
The Power Save featurehelps to conserve your battery power
when you are in an area where ther
eis no signal.
END
Phone Basics