User's Manual
Table Of Contents
- Sanyo Katana II User Guide
- Introduction
- Your Phone's Menu
- Getting Started
- Using Your Phone
- Phone Basics
- Controlling Your Phone's Settings
- Setting Your Phone's Security
- Controlling Your Roaming Experience
- Managing Call History
- Using Contacts
- Adding a New Contacts Entry
- Assigning a Group Entry
- Finding Contacts Entries
- Editing a Contacts Entry
- Contacts Entry Options
- Assigning Speed Dial Numbers
- Erasing a Contacts Entry From the List
- Assigning an Image to a Contacts Entry
- Assigning a Ringer Type to an Entry
- Secret Contacts Entries
- Dialing Sprint Services
- Using the Phone’s Calendar and Tools
- Using Your Phone’s Voice Services
- Using the Built-in Camera
- Using Bluetooth®
- Sprint Service Features
- Safety and Warranty Information
- Index
Section 4A: Important Safety Information 211
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
v
Reorient the direction of the internal antenna.
v
Increase the separation between the equipment and receiver.
v
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
v
Consult the dealer or an experienced radio/TV technician for help.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Important Safety Information