Operation Manual

English - 37 -
Select Dot Clock item by using or
buttons. Use / button to adjust the value.
Phase
Depending on the resolution and scan
frequency that you input to the TV set, you may
see a hazy or noisy picture on the screen. In
such a case you can use this item to get a
clear picture by trial and error method.
Select Phase item by using
or buttons.
Use

/

button to adjust the value.
No-Signal and Out Of Range Detection
(PC mode)
In PC Mode,as no menu is displayed,in case
that there is no PC input to the TV,it is displayed
an OSD message:
No PC input
then the power lamp turns to amber and PC
will be in PC standby mode. Press digit buttons
or “P+” / “P-” buttonsto exit standby mode.
In PC Mode,as no menu is displayed,in case
that there is no PC input to the TV, but the
resolution and the vertical frequency is not
supported by the concept, it is displayed an
OSD message:
Out of range
Displaying TV Information
Programme Number, Programme Name,
Sound Indicator and Zoom Mode information
is displayed on the screen when a new
programme is entered or
button is pressed.
Mute Function
Press button to disable sound. Mute
indicator will be displayed in the upper side
of the screen.
To cancel mute, there are two alternatives; the
first one is pressing the
button and the
second one is increasing the volume level.
PIP (Picture-in-Picture) and PAP
(Picture-and-Picture) Modes
Press the button to switch to PIP mode.
At PIP Mode, a small picture (PIP picture) is
displayed on the main picture. There are 1
size and 4 positions (upper left, upper right,
bottom left and bottom right) available for the
PIP window. You can use
button to change
the PIP position. Aspect Ratio of the PIP
window is fixed and 4:3.
When PIP Mode is entered, the default active
window is the PIP window and the active
window is indicated by a white frame around
it. The active window can be changed by
pressing

/

button. The status info OSD
belongs to active window. The place of the
status OSDs are same for both windows.
Press the
button again to exit the PIP
mode.
Press the
button to switch to PAP mode.
At PAP Mode, two pictures with equal sizes
are displayed on the screen. Aspect Ratios of
the windows are fixed.
When you switch to PAP Mode, Main window
in PIP Mode is displayed on the right side of
the screen. The active window can be
changed by pressing

/

button.
Press the
button again to exit the PAP
mode.
Source restrictions of PAP Mode are same as
in PIP Mode. It is not possible to show 2 different
channels from the TV tuner at the same time.
NOTE: In all HDMI modes, PIP and PAP are not
visible. In YPbPr 1080i, PIP is not visible.
NOTE: See Appendix B for all PIP/PAT modes.
ENG-47751W-MB26 UK IDTV-1050UK-(WSUB-ALO-2SCRT)(3D PANORAMA)(ECO PIP)(C2)-50110360.p6506.07.2007, 22:1837