User's Manual

9
Part Names and Functions
Rear Terminal
⑥ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.15).
⑧ AUDIO IN
Connect the audio output signal from video
equipment connected to ⑥ or ⑨ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.15).
⑩ COMPUTER AUDIO IN 1
Connect the audio output (stereo) from a
computer or video equipment connected to ③ to
this jack (pp.14, 16).
⑨ VIDEO IN
Connect the composite video output signal to
this jack (p.15).
③
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal(pp.14,16).
⑤ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14-16).
This terminal outputs sound from AUDIO IN terminal
(⑧ or ⑩).
Never plug headphones and earphones into AUDIO
OUT jack.
① LAN Connection Terminal
Connect the LAN cable (refer to the owner’s manual
of "Network Set-up and Operation").
⑦ CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
④ MONITOR OUT
This terminal can be used to output the incoming
analog RGB signal and component signal from
COMPUTER IN 1/COMPONENT IN terminal
or COMPUTER IN 2/DVI-I terminal to the other
monitor (pp.14,16).
⑪ COMPUTER AUDIO IN 2 (MIC IN)
Connect the audio output (stereo) from a
computer or video equipment connected to ② to
this jack. Or connect the MIC to the this jack
(pp.14, 16, 24).
③
④
①⑤
⑥
⑪
⑦
⑨
⑧
⑩
②
② COMPUTER IN 2 / DVI-I
Connect computer output (Digital/Analog DVI-I type)
to this terminal (p.14).