User's Manual

14
Installation
Connecting to a Computer
Unplug the power cords of both the projector and external equipment
from the AC outlet before connecting cables.
✔Note:
• Input sound to the AUDIO IN terminal when using the COMPUTER IN 1/
S-VIDEO IN / COMPONENT IN
and the COMPUTER IN 2/MONITOR OUT terminals as input.
• When the AUDIO OUT is plugged-in, the projector's built-in speaker is not
available.
• When the cable is of the longer variety, it is advisable to use the COMPUTER
IN 1 /S-VIDEO IN /COMPONENT IN and not the COMPUTER IN 2/MONITOR
OUT.
Cables used for connection
• VGA Cables (Mini D-sub 15 pin)
• VGA/DC power combined cord (supplied)
• Audio Cables
External Audio Equipment
Audio cable
(stereo)
Audio cable
(stereo)
Audio Output
AUDIO IN
AUDIO OUT
(stereo)
Audio Input
Monitor Input
or
Monitor Output
COMPUTER IN 2 /
MONITOR OUT
VGA
cable
COMPUTER IN 1
/ S-VIDEO IN
/COMPONENT IN
VGA
cable
Monitor
Output
This terminal is switchable. Set up
the terminal as either Computer input
or Monitor output. (See Page 49.)
RGB
Output
DC IN 12V
VGA/DC power
combined cord
(supplied)
DC OUT 12V
Document Camera
Note:
Use only the supplied VGA/DC powerUse only the supplied VGA/DC power
combined cord. (Document camera
can be powered separately by AC/
DC power supply came with the
ELMO document camera "L-1ex/
TT-02RX" or "L-1n/TT-02s".)
✔Note:
• The cap is installed before shipping.
• Keep the cap installed when the DC
OUT termnial is not used to avoid
audio cable connecting to DC OUT
terminal.
• Take off the cap and connect the
cable when using DC OUT terminal.
Keep the cap carefully for later use.
DC OUT
terminal cap