SANS SYSTEMS THE UNION OF FORM AND FUNCTION Assembly Instructions for Model: MT Thank you for choosing a Anus Systems VisionMount™ wall mount The MT is designed to mount up to 40" [1016 mm] LCD TVs weighing less than 100 tbs [45 Kgl to a vertical wall.
Step 1: Mount Monitor Brackets to a television with a flat back NOTE: For televisions with a curved back, or an obstruction near the threaded insert see Step 2. Determine the diameter of the Belt your TV requires by hand threading them into the threaded insert on the back of the TV. If you encounter any resistance stop immediately.
Step 2: Mount Monitor Brackets to a television with a curved back or an obstruction near the threaded insert Determine the diameter of the Bolt your TV requires by hand threading them into the threaded insert on the back of the TV. If you encounter any resistance stop immediately. Once you have determined the correct diameter bolt, see the appropriate Diagram below, thread the Bolt through the appropriate Lock Washer the corresponding Washer the Monitor Bracket a Spacer and finally into the TV.
Step 3: Mount the Wall Plate: Wood Stud, Brick, Solid Concrete, and Concrete Block mounting options are provided, WOOD STUD MOUNTING: CAUTION: Do not over tighten the Lag Bolts {D). Tighten Lag Bolts only until the Lag Bolt Washer {E} is pulled firmly against the Wall Plate, if there is a layer of drywall or other material, this drywall or other material may not exceed 5/8 inch [15.8 mm] in thickness. Failure to heed this caution may result property damage landlord personal injury.
