MSF07c Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE Before getting started, let’s make sure this mount is perfect for you! 1 Does your TV weigh more than 35 lb (15.8 kg) including accessories? 35 lb No — Perfect! (15.8 kg) Yes — This mount is NOT compatible. Visit MountFinder.Sanus.com or call 1-800-359-5520 (UK: 0800-056-2853) to find a compatible mount.
Dimensions in. [mm] 7.87 200.0 3.94 100.0 2.95 75.0 20° 6.87 174.6 8.87 225.4 2.95 75.0 3.94 100.0 4.75 120.7 2.56 65.0 4.70 119.3 OFFSET 12° 7.87 200.0 7.18 182.4 8.80 223.
Parts and Hardware WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts! NOTE: Not all hardware included will be used. Parts and Hardware for STEP 1 TV Interface Bracket/Wall Plate Assembly Lag Bolts 5/16 x 2 ½ in.
Parts and Hardware for STEP 2 Washers TV Screws M4 x 12mm Extender Brackets* Extender Bracket Nuts* M4 x 35mm 06 x4 03 x4 M4/M5 M6 09 x4 M5 x 12mm 13 x4 10 x4 M5 x 35mm 04 x4 07 x4 Spacers 12 x2 M6 x 12mm M6 x 35mm 05 x4 08 x4 11 x4 *Only needed for TVs with 200x200 mm (7 7⁄8 x 7 7⁄8 in.) hole patterns Additional Hardware 7/32 in. Hex Key 7/32 in.
Before You Begin - Consider TV Location and Offset IMPORTANT: When choosing a location for your TV on the wall, please keep in mind that the TV will shift 119.3 mm (4.7 in.) from the EXTENDED to the HOME positions. HOME 182.4 mm (7.18 in.) 119.3 mm (4.7 in.
STEP 1 Attach Wall Plate to Wall - Wood Stud ONLY! 1. 2. 1 Locate your stud. Verify the center of the stud using an awl, a thin nail, or an edge to edge stud finder. CAUTION: Avoid potential personal injuries and property damage! ƕ Drywall covering the wall must not exceed 16 mm (5/8 in.). ƕ Minimum wood stud size: common 51 x 102 mm (2 x 4 in.) nominal 38 x 89 mm (1½ x 3½ in.). Level the wall plate 01 and mark the hole locations. ≤ 16 mm (5/8 in.
3. Drill pilot holes. IMPORTANT: Pilot holes must be drilled to a depth of 63.5 mm (2½ in.), using a 5.5 mm (7/32 in.) diameter drill bit. 4. Tighten the lag bolts 02 only until they are pulled firmly against the wall plate 01 . CAUTION: Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts. 3 4 63.5 mm (2½ in.) 01 5.5 mm (7/32 in.
STEP 2 Attach TV Bracket to TV SELECT TV HARDWARE 1. 2. 1 Hand thread screws into the threaded inserts on the back of your TV to determine the correct screw diameter (M4, M5, or M6). Determine what kind of TV you have and if you require extra space between the wall and the TV to accommodate cables.
IMPORTANT: If the hole pattern on your TV is 200x200 mm (7 7⁄8 x 7 7⁄8 in.) install the extender brackets 12 using the nuts 13 provided. If your TV hole pattern is less than 200x200 mm do not install the extender brackets. Skip ahead to STEP 2-A or 2-B.
STEP 2A Install the top two screws but do not fully tighten. Leave a small gap so you can slide the TV bracket into place and then install the bottom two screws. Ensure that your bracket is level on the back of the TV. If you need extra space to accommodate cables, recesses, or protrusions; use spacers (see the irregular back option in STEP 2-B). HEAVY! You may need assistance with this step.
NOTE: If the hole pattern on your TV is 200x200 mm, install all four screws at the same time. NOTE: If the hole pattern on your TV is 75x75mm the washers are not used. Install all four screws at the same time.
STEP 2B Install the top two screws but do not fully tighten. Leave a small gap so you can slide the TV bracket into place and then install the bottom two screws. Ensure that your bracket is level on the back of the TV. Standard configurations are shown. For special applications, or if you are unsure about your hardware selection, contact Customer Service. HEAVY! You may need assistance with this step.
NOTE: If the hole pattern on your TV is 200x200mm, install all four screws at the same time. NOTE: If the hole pattern on your TV is 75x75mm the washers are not used. Install all four screws at the same time.
Manage Cables 1 2 01 01 NOTE: Leave enough slack in the cables to allow the TV to move freely.
Troubleshooting ADJUSTING TENSIONS REMOVING THE TV SWIVEL EXTEND/RETRACT If you need to remove your TV, disconnect all cables and then reverse the procedures in STEP 2A /2B. 7/32 in. TILT 01 Loosen the knob on the TV bracket to adjust the tilt of your TV. Tighten the knob when your TV is set to the desired tilt.
ESPAÑOL INSTRUCCIONES DE SEGURIDAD IMPORTANTES. CONSÉRVELAS. LEA TODO EL MANUAL ANTES DE UTILIZAR ESTE PRODUCTO. Antes de comenzar, verifiquemos que este soporte sea el ideal para sus necesidades. 1 ¿Su televisor pesa más de 15.8 kg (35 lb), incluidos los accesorios? No — ¡Perfecto! 15.8 kg Sí — Este soporte NO es compatible. Visite MountFinder.Sanus.com o llame al 1-800-359-5520 (Reino Unido: 0800-056-2853) para encontrar un (35 lb) soporte compatible.
ESPAÑOL Dimensiones Ver página 3 Piezas y elementos de sujeción suministrados Ver página 4 ADVERTENCIA: Este producto contiene piezas pequeñas que, si fuesen tragadas, podrían producir asfixia. Antes de iniciar el ensamblaje, compruebe que todas las piezas estén incluidas y en buenas condiciones. Si faltan piezas o alguna está dañada, no devuelva el artículo al distribuidor; póngase en contacto con el servicio de atención al cliente. Nunca utilice piezas deterioradas.
ESPAÑOL PASO 2 Fijar la placa de sujeción al televisor 1. 2. Ver página 10 Enrosque manualmente los tornillos en los encastres roscados de la parte posterior del televisor a fin de determinar el diámetro correcto de los tornillos (M4, M5 o M6). Determine qué tipo de televisor tiene y si necesita espacio adicional entre la pared y el televisor para colocar cables.
ESPAÑOL PASO 2-b Fijar la placa de sujeción al televisor Ver página 14 Instale los dos tornillos superiores pero no los ajuste completamente. Deje un espacio pequeño para poder deslizar la placa de sujeción del televisor en su lugar y luego instalar los dos tornillos inferiores. Asegúrese de que la placa de sujeción quede nivelada en la parte posterior del televisor. Se ilustran las configuraciones estándar.
FRANÇAIS CONSIGNES DE SÉCURITÉ IMPORTANTES – CONSERVEZ CES INSTRUCTIONS – VEUILLEZ LIRE ATTENTIVEMENT LE MANUEL AVANT D’UTILISER CE PRODUIT Avant de commencer, assurons-nous que ce support vous convient parfaitement! 1 Votre téléviseur pèse-t-il plus de 15.8 kg (35 lb) avec les accessoires? 15.8 kg (35 lb) 2 3 Non — Parfait! Oui — Ce support n'est PAS compatible. Visitez MountFinder.Sanus.com ou composez le 1 800 359-5520 pour trouver un support compatible.
FRANÇAIS Dimensiones Dimensions Voir à la page 3 Pièces et matériel fournis Voir à la page 4 AVERTISSEMENT: Ce produit contient de petites pièces qui peuvent représenter un risque d’étouffement. Avant de commencer l’assemblage, assurez-vous que toutes les pièces sont présentes et qu’elles ne sont pas endommagées. Si une pièce est manquante ou endommagée, ne retournez pas les pièces endommagées à votre revendeur. Contactez plutôt le service clientèle.
FRANÇAIS ÉTAPE 2 Installation des supports du téléviseur Voir à la page 10 Choix des vis pour le téléviseur Le type de téléviseur vous aidera à choisir la configuration de la quincaillerie à utiliser. Faites correspondre votre type de téléviseur à l'une des configurations de quincaillerie suggérées à la page suivante. a - Option d'installation sans entretoises (téléviseur à dos plat). b - Option d'installation avec entretoises (téléviseur avec dos obstrué ou avec trous de montage encastrés).
FRANÇAIS Gestion des câbles Voir à la page 16 REMARQUE : Assurez-vous de laisser suffisamment de mou dans les câbles pour que le moniteur puisse bouger librement. Dépannage RÉGLAGE DE L'INCLINAISON : Desserrez le bouton sur la bride de montage du téléviseur pour ajuster l'inclinaison du téléviseur. Serrez le bouton lorsque le téléviseur est à l'angle d'inclinaison désiré.
Thank you for choosing Sanus Classic! Please take a moment to let us know how we did: Call us: 1-800-359-5520 UK: 0800 056 2853 Email us: info@sanus.com Find us on Facebook: SANUS Leave a review: sanus.com Follow us on Twitter @sanussystems Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete.
