Owner's Manual
3
Mount
the Wall Plate
Solid Concrete or Concrete Block
Level the wall plate [01] and mark
the
hole locations.
A
CAUTION:
Avoid potential injuries or property damage!
x
Mount
the
wall plate [01] directly
onto
the
concrete surface.
•
Minimum
solid concrete thickness: 203mm
(8
in.).
x
Minimum
concrete block
size:
203 x 203 x 406
mm
(8
x 8 x 16 in.).
x
Minimum
space between fasteners: 406
mm
(16
in.).
3-2
Drill
~:::;:::;;;;;;;:::;=:::;:::;;;;;;;;;;;:~;::::::;:::;:::;:::;;;=:::;:::;:::;:::;;;::1 A
CAUTION:
Avoid potential injuries or property damage!
x Pilot holes MUST be drilled
to
a depth
of
75
mm
(3
in.) using a 10
mm
(3/8 in.) diameter drill bit.
• Never drill
into
the
mortar between blocks.
3-3 Insert anchors and wall plate screws
Insert wall plate screw anchors [04]. Then insert wall plate
screws [03] using a drill and the alien driver
bit
[05].
____________
....,
_____________
A
CAUTION:
Improper use could reduce
the
holding
8
power
of
the lag bolt.
To
avoid potential injuries or property
damage:
•
Be
sure the anchors [04] seat flush
with
the
concrete
surface.
• Tighten
the
wall plate screws [03] only until the they are
pulled firmly against
the
wall plate [01
].
6901-602126
00