Owner's Manual

3 Mount the Wall Plate
Wood Stud Mounting
3-1 Locate studs
. :.
I .
I
I
I
~
3-2 Mark the wall
[01
LL11
406-609 mm (16-24 in.)
ML11
406 mm (16 In.)
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Locate studs. Verify the center of the stud(s) using an awl or edge to
edge stud finder .
A CAUTION: Avoid potential personal injuries and property
damage!
x Drywall covering the wall must not exceed 16 mm (5/8 in.).
x Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (11/2 x 31/2 in.).).
Level the wall plate [01] and mark the hole locations.
3-3 Drill
~====~~;;;;;;~~~;;;;;;;;======~~=~ A CAUTION: Avoid potential injuries or property damage! Pilot
X
holes MUST be drilled to a depth of 70 mm (2¾ in.), using a 5mm
(3/16 in.) diameter drill bit.
Using a drill and the alien driver bit [OS] tighten wall plate screws
[03] only until they are pulled firmly against the wall plate.
~=:::::::::::::::::::===~=:;::;::=;=======I A CAUTION: Avoid potential injuries or property damage!
x DO NOT over-tighten the wall plate screws [03].
6901-602126 00
x Tighten the wall plate screws only until they are pulled firmly
against the wall plate [01 ].
7