SANTOS SAS: 140-150 AVENUE ROGER SANTOS : User andSALENGRO maintenance manual 69120 VAULX-EN-VELIN (LYON) - FRANCE TÉL. 33 (0) 472 37 35 29 - FAX 33 (0) 478 26 58 21 TELECOPIE 33 (0) 478 26 58 21 E-Mail :santos@santos.fr www.santos.
SANTOS : User and maintenance manual CONTENTS “CE” COMPLIANCE DECLARATION ........................................................................................ 3 IMPORTANT SAFEGUARDS ........................................................................................................ 4 IMPROPER USE ............................................................................................................................. 4 ELECTRICAL CONNECTION: ......................................................
SANTOS : User and maintenance manual “CE/UE” COMPLIANCE DECLARATION THE MANUFACTURER: SANTOS SAS - 140-150, Av.
SANTOS : User and maintenance manual IMPORTANT SAFEGUARDS When using, cleaning or maintaining the machine, always follow these instructions: Read all instructions Note: For easier understanding of the sections below, please refer to the diagrams at the end of the manual IMPROPER USE 1. Do not use this appliance for grinding anything other than roasted coffee beans. 2. Never operate the appliance with no coffee beans in the bean container. 3.
SANTOS : User and maintenance manual CARE: • Before connecting the machine, check that the mains electrical voltage is the same as the voltage for your appliance. Its value is shown: ➢ either on the identification plate (16) under the machine. ➢ or on the identification plate on the last page of this manual. ! • If the power cable (10) is damaged, it should be replaced by a SANTOS approved dealer, SANTOS or a person with similar qualifications to avoid any danger.
SANTOS : User and maintenance manual YOUR ESPRESSO COFFEE GRINDER #40A - 40APPM, #06 – #06A • • • • • • The silent bar espresso coffee grinder #40A, #06-06A is designed for bars, cafés, hotels and restaurants. It is suitable for all types of espresso coffee machines. Grinder #40A / #6A has, in addition, an automatic start/stop device to ensure a constant level of ground coffee in the distributor.
SANTOS : User and maintenance manual starts again, after a few measures, when the ground coffee level has dropped sufficiently. Because of this, the machine can be left with the electric power on in position 1 all the time it is being used. Coffee grinding adjustment: Note: Never leave the machine to run with the two grindstones in contact. If the grindstones make contact this may result in ground coffee getting jammed in the grinder body and premature wear of the grindstones.
SANTOS : User and maintenance manual CLEANING: IMPORTANT: • • In every case, the machine should be stopped and the machine's power supply cable (10) unplugged. Cleaning with a water spray or pressure spray is not permitted Clean the dose measurer properly using a brush. Make sure that the walls of the coffee delivery conduits and the 6 branches of the cross-bars are always clean.
SANTOS : User and maintenance manual The 2 grindstones are identical and can be fitted equally either on the moving plate (18) (moving grindstone) or on the adjusting "nut" (5) (fixed grindstone) (fig. F). 1. Close the bean shutter (6) (fig. G) . 2. Run the machine until the coffee beans waiting in the grinder body have gone through. 3. Stop the machine and unplug the mains power lead (10). 4. Take off the bean container (2). 5.
SANTOS : User and maintenance manual FAULT FINDING Carefully determine the reason for the machine stopping. In all circumstances, if the problem persists, disconnect the electric power supply (unplug the mains supply lead plug (10)) and call on someone from the maintenance department or contact an approved SANTOS dealer. Where appropriate, do not forget to close the bean container shutter (6) before removing the container.
SANTOS : User and maintenance manual The machine stops a few minutes after starting. • Check the electric components (start relay). If the problem persists, turn the machine electric power off (unplug the mains power lead (10)) and call on someone from the maintenance department or contact an approved SANTOS dealer. The ground coffee measure is not even • Check that there are coffee beans in the bean container • Clean the coffee dose measurer.
SANTOS : User and maintenance manual MACHINE TECHNICAL SPECIFICATIONS ELECTRIC SPECIFICATIONS (1) model Supply voltage Frequency Motor: rating Input power Speed: 40A -40A PPM 06 – 06A .(V) (Hz) 220-240 110-120 50/60 50/60 (W) (rpm) 360 310 1450 at 50Hz,1700 at 60Hz Bean container capacity Grindstone diameter Average output Dose measurement adjustment (approx.) Dose measurer capacity Automatic start and stop (40A – 40A PPM – 06A only) (kg) (mm) (kg/h) (g) (kg) 2.2 63.5 8 From 5.5 to 9.5 0.
SANTOS : User and maintenance manual 110-120V 50/60Hz wiring diagram White Capacitor Black M White Brown Yellow Red 2 4 3 Start relay Red Amperometric protection Dose measurer safety device White Blue On / Off White Black White ~ White Green / Yellow 98140 EN 4.2 - 09 2021 13 / 20 www.santos.
SANTOS : User and maintenance manual 220-240V 50Hz wiring diagram Since 2014 Blue M Black Capacitor White 180 White 2 Red 4 Red Amperometric protection 3 Start relay Dose measurer safety device Violet 200 Brown 600 On / Off White 240 ~ White 240 Green / Yellow 98140 EN 4.2 - 09 2021 1x240 1x350 14 / 20 www.santos.
SANTOS : User and maintenance manual 220-240V 60Hz wiring diagram White Red Capacitor Blue M White 180 Grey Black Yellow 2 4 3 Start relay Red Dose measurer safety device Amperometric protection Violet 200 Brown 600 On / Off White 240 ~ White 240 Green / Yellow 98140 EN 4.2 - 09 2021 1x240 1x350 15 / 20 www.santos.
SANTOS : User and maintenance manual Element cross-reference table ITEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Description Bean container lid Bean container Ground coffee collector Base Grinder body Bean container shutter Indexing pointer Coffee measure adjustment thumb-wheel Grindstone Power supply lead plug On / Off switch Graduated plate Excess current protection Start relay Capacitor Identification plate Motor spindle nut Grindstone-carrier plate Automatic device unit Ground c
SANTOS : User and maintenance manual Figures 1 1 2 2 6 5 6 24 5 4 19 24 7 19 21 4 11 20 10 20 11 3 22 21 22 98140 EN 4.2 - 09 2021 Fig. A 17 / 20 www.santos.
Fig. A Fig. B 1 SANTOS : User and maintenance manual 2 20 21 23 6 24 5 22 4 19 3 Fig. C 11 10 20 5 3 21 22 Fig. D 7 8 Fig. E 15 16 Fig. G 13 20 6 14 Fig. F 9 9 98140 EN 4.2 - 09 2021 18 / 20 www.santos.
Fig. H Fig. I Meule mobile SANTOS : User and maintenance manual 5 Meule fixe 7 Fig. K Fig. J 17 5 18 7 Fig. L Fig. N 12 5 20 7 Fig. O Fig. M 13 19 98140 EN 4.2 - 09 2021 19 / 20 www.santos.
SANTOS : User and maintenance manual WARRANTY CERTIFICATE WARRANTY Since the 01.01.95, all our appliances comply with CE and possess the CE label. Our guarantee is of 24 months from the manufacturing date mentioned on the descriptive plate, except concerning the asynchronous motors (consisting of a rotor and a stator) which are warranted for 5 years from their manufacturing date.
