Specifications

Multipoint
7
7
3.1 Select appropriate push t connector for chosen entry position:
Bottom entry water - 15mm x 15mm 90º elbow.
Rear entry water - 15mm x 15mm straight.
Note: stainless or chromed pipes DO NOT provide secure connections with
push t ttings (use copper pipe at joints).
3.2 Push the connector fully home (28mm engagement) onto the solenoid valve
inlet spigot. To remove a push t connector the collar (collet) should be pushed
towards the body of the tting whilst pulling the connector off the pipe.
3.3 If the inlet pipe run is horizontal and beneath the unit ensure it does not prevent
access to the case screws.
3.4 Connect the inlet pipe to the push t connector ensuring it is fully pushed home
(28mm engagement). After connection DO NOT make soldered joints in the
pipe work close to the heater, as the heat may damage the connector or the water
heater itself.
3.5 A WRAS listed isolating valve should be tted to the cold supply to facilitate
servicing the heater.
3.6 Push t connectors are supplied to allow either bottom or rear entry of services.
3.0 INSTALLATION - WATER SUPPLY
4.0 INSTALLATION - VENT PIPE
4.1 Select appropriate push t connector for chosen entry position:
Bottom entry vent - 15mm x 15mm straight
Rear entry vent - 15mm x 15mm 90º elbow
4.2 Push the connector fully home (28mm engagement) onto the vent pipe
connection.
4.3 Connect the vent pipe to the push t connector ensuring it is pushed fully
home (28mm engagement). Refer to the vent pipe requirement detailed in
IMPORTANT INSTALLATION POINTS. If a bottom entry vent pipe is used
the pipe must terminate below the unit, in a safe visible position. After
connection DO NOT make soldered joints in the pipe work close to the heater,
as the heat may damage the connector or the water heater itself.
FIXING
POINT
SP2.5
SP5.0
SP7.5
CABLE
ENTRY
FIXING
POINT
I
J
BRACKET
BRACKET
BRACKET
OUTLET
K
L
M
N
O
59
61
61
96
117
117
50
67
67
342
401
401
52.5
84
84
169
217
217
152
163
225