Specifications
2
Thank you for purchasing a Santon Speediboil . The Boiling water heater is manu-
factured to the highest standards and has been designed to meet all the latest relevant
safety specications.
This Santon water heater must be installed (Sections 1-5), commissioned (Section
6) and maintained (Sections 7-8) by a competent person. Please read and understand
these instructions prior to installing your Santon water heater. Following installation
and commissioning the operation of the heater should be explained to the user (Section
10) and these instructions left with them for future reference.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.
COMPONENT CHECKLIST
Before commencing installation check that all the following components have been
supplied with your Speediboil heater.
Wall mounting bracket•
No.12 x 2” screws (2 off)•
No.8 x 1” screw (1 off)•
No.12 x 2” wall plug (2 off)•
No.8 x 1” wall plug (1 off)•
15mm x 15mm straight push-t connector (tted)•
15mm x 15mm 90 ° elbow push t connector (tted)•
INTRODUCTION