Specifications

8
5.0 COMMISSIONED
5.1 Once installed, the heater will operate automatically when the outlet valve is
opened. The valve must be opened fully to obtain the set ow/temperature.
Reduced ow at the outlet will result in hotter water being delivered.
5.2 On closing the outlet valve the heating element will automatically shut down
once ow is reduced to a small amount.
SETTING FLOW RATE
5.3 It is important to note when setting the ow rate/temperature that 118°F is the
point at which the average person cannot hold his or her hand under a stream of
water. Under most circumstances water temperature need not be higher than
this and it is recommended that this temperature is not exceeded.
5.4 These heaters will supply only one outlet at any time and must be controlled by
a single outlet valve. DO NOT USE WITH MIXER VALVES.
4.17 Turn the isolating stop valve on slowly and check for leaks in all pipe work,
rectify as necessary.
4.17 Turn off the isolating stop valve.
4.18 Place the cover onto the back plate.
4.19 Secure the cover to back plate using screws provided.