Specifications

INTRODUCTION

Thank you for purchasing a Santon Power Pack. The Power Pack unvented pressure

system water heater is manufactured to the highest standards and has been designed to

meet all the latest relevant safety specications.

This Power Pack water heater must be installed (Sections 3.0-6.0), commissioned

(Section 5.0) and maintained (Section 7.0) by a competent person. Please read and

understand these instructions prior to installing your Power Pack unvented pressure

system water heater. Particular attention should be paid to the section headed SAFETY

(section 2.0).

This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning the use of the appliance by

a person responsible for their safety. Children should be supervised to ensure that they

do not play with the appliance.

TECHNICAL SPECIFICATION

CONNECTIONS

Inlet / Outlet connection -1/2” BSP

Water entry point - bottom

Cable entry point - bottom/rear

ELECTRICAL

Model numbers

7.0kW - 94 805 005

9.0kW - 94 805 006

Electrical rating........................................................................... 6.4/7.0kW @ 230/240V

.....................................................................................................8.3/9.0kW @ 230/240V

PACK CONTENTS

Heater

Fixing screws and plugs

Pressure relief valve 0.85MPa (8.5bar)

Installation and User Instructions