Specifications

Multipoint
5
ELECTRICAL
2.20 Before tting the appliance, ensure that the consumer unit and any switches
are suitable for the additional load. If in doubt, contact your electricity
supplier or a qualied electrician.
2.21 The installation must comply with BS 7671 ‘Requirements for electrical
installations’ (IEE Wiring Regulations).
CAUTION
2.22 This appliance must be earthed.
2.23 Fuses do not give personal protection against electric shock. To enhance
electrical safety a 30mA residual current device (RCD) should be
installed in all electric hand wash circuits. This may be part of the
consumer unit, or a separate unit.
2.24 Ensure that all terminal block connections are sufciently tight.
2.25 Switch off appliance immediately and isolate if water ceases to ow during
use.
2.26 Other electrical equipment e.g. extractor fans, must not be connected to the
hand wash or its supply circuit.