Specifications
2
INTRODUCTION
Thank you for purchasing a Santon EV2008 Hand wash. The Hand wash instantaneous
water heater is manufactured to the highest standards and has been designed to meet
all the latest relevant safety specications.
This Hand wash instantaneous water heater must be installed (Sections 4.0-7.0),
commissioned (Section 7.0) and maintained (Sections 8.0 - 9.0) by a competent
person. Please read and understand these instructions prior to installing your
Hand wash instantaneous water heater. Particular attention should be paid to the
section headed SAFETY (section 2.0). Following installation and commissioning
the operation of the heater should be explained to the user (Section 7.0) and these
instructions left with them for future reference.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety. Childern should be supervised to ensure that they
do not play with the appliance.
TECHNICAL SPECIFICATION
CONNECTIONS
Inlet connection -15mm ext. diameter (copper or push t stem elbow)
Water entry point - bottom and rear
Cable entry point - bottom and rear
ELECTRICAL
Model numbers
3.1kW - Hand wash - 94 020 017
Electrical rating..........................................................................2.9/3.1kW @ 230/240V
Ampre rating..............................................................................2.9/3.1kW @12.4/12.9A
MATERIALS
Backplate, cover and control knob- ABS
Element(s) - Copper sheathed rod type.
DIMENSIONS
Height - 235mm
Width - 151mm
Depth - 85mm
STANDARDS AND APPROVALS
Complies with the requirement of EN 60335-2-35.
British Electro technical Approvals Board (BEAB) approved.
Complies with European Community Directives (CE).
Complies with uk water regulations, kiwa approved.