Specifications

10
PIPE ENTRY
4.9 Plumbing entry can be from the rear (preferred) or from the bottom. The
backplate has a cut out position to suit 15mm pipe. When opting for
bottom entry make cut out before tting backplate to the wall - see
Figure 6.
5.1 TURN OFF water and electrical supply.
5.2 The appliance is designed for bottom and rear entries of water and electric
cable. It is advisable to use the rear entry (when it is possible), in order
to obtain a neater installation.
5.3 Unscrew the retaining screws and lift the cover from the back plate -
see Figure 7.
5.0 FITTING INSTRUCTIONS
5.4 Fit the outlet spout - DO NOT over tighten, nger tight will be sufcient
- see Figure 8.
5.5 After choosing the correct site for the hand wash, use the backplate as a
template and mark the two xing holes - see 4.1 to 4.7.
BEWARE OF CABLES AND PIPES WHICH MAY BE BURIED IN THE
WALL.
5.6 Drill holes using a 6.5mm diameter masonry drill.
5.7 Use plugs to suit the wall and use the xing screws supplied.
Cable
Clamp
Inlet water
connection
Terminal
Block
Rear entry access
area for electricity and
inlet water supply
Figure 9 Unit layout - Dimensions (mm)
86
19.5
196.5
74
29
235
151
Figure 7 Removing Cover
Figure 8 Fitting outlet spout
'O' rings
Plastic nut
(finger tight only)
Outlet pipe
Make cut-out
using sharp knife
Figure 6 Plumbing cut-out