User manual

User Manual
SVS-3001
_________________________________________________________________________________
- 22 -
2.4.2 PTZ
The camera setting can be found under the path: Camera > PTZ
PTZ status:
Select “enable” or “disable. The PTZ control panel in live view is only displayed if the PTZ
status is set to “enable”.
PTZ protocol:
The following protocols are supported: Pelco D, Pelco P, Li-Lin, Li-Lin New, Dynacolor.
Device ID:
Set the ID for the video server (1-63).
Speed (only applicable if speed domes are used):
Adjust the speed of the speed dome (1-10).
Port mode:
Select RS-485, RS-232 or PTZ.
Baud rate:
Transmission speed to/from PTZ device.
Data bit:
Data transfer rate.
Stop bit:
A start signal is sent prior to each byte, character or code word and a stop signal is sent after
each code word.
Parity:
Parity of an object states whether it is even or odd.