User manual

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 41 -
Step 5:
Mark the positions of the four screw holes on
the base plate at the chosen installation
location.
Step 6:
In the marked locations, drill each hole slightly smaller than the supplied screw anchors.
Put the supplied anchors into these drilled holes.
Step 7:
For surface-mount installations, it is recommended to stick the large black washer
underneath the housing plate to ensure a water-proof installation.
Step 8:
Fasten the housing plate with the four supplied self-tapping screws by piercing through the
black washer.
Step 9:
Use a coin to screw off the silver-metal conduit entry plug on the bottom of the housing plate
if you wish to lead the cables through here. If this is not the case, you may want to use one
of the white stickers and stick them onto the silver-metal plug to give the housing a uniform
white look.
Cut a whole into the membrane plug.
Insert the membrane plug either into the side or the bottom hole of the housing base.
Thread the cables (power/Ethernet/audio/alarm) through the membrane plug.
(The power cable is omitted if using PoE.)