User manual

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 17 -
QUICK INSTALLATION GUIDE: SNC-8322HO, SNC-8322I
Caution:
When taking the speed dome out of the box, do not lift it by its housing top. The top is not
screwed tight and may come off when taking the dome out of the box, hence the entire dome
may fall down.
To operate the speed dome, please follow these steps:
1. Take off the housing top and remove the transport securing devices ( adhesive tape
on lens, filling material on housing top’s inner side, lens cover).
2. Mount the bracket (may also serve as a drilling hole scheme) to the ceiling and lead
the cables through the bracket.
3. Connect the LAN cable to the speed dome. If you don’t use PoE, a power adapter
with open cable ends is required plus a power plug (included in the delivery)..
Note: The built-in heater of camera SNC-8322HO only operates when 24 V AC is
used (and not PoE).
4. Mount the speed dome to the ceiling bracket. Turn the dome a bit until the fixing
screw is in the right position and you can screw it tight to the bracket.
5. Put the housing top back and screw it tight.
6. Insert the CD (included in the delivery) into your PC/laptop and install the IP-finder.
7. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn’t work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
IP address:
The camera comes with a default IP address:
Default IP address: 192.168.1.168 (or by DHCP, if available)
User name: admin
Pass word: 9999
Connect to power (24 V AC): Connect to audio:
Alarm I/O connection:
Please refer to the following chapters in this user manual for further installation information
and on camera configurations.
Pin
Description
1
AC 24_1
2
GND
3
AC 24_2
Pin
Description
3
LINE_IN
2
GND
1
LINE_OUT
Pin
Description
Pin
Description
1
ALARM_OUT_NO_1
7
ALARM_OUT_COM_2
2
ALARM_OUT_NC_1
8
GND
3
ALARM_OUT_COM_1
9
ALARM_IN_4
4
GND
10
ALARM_IN_3
5
ALARM_OUT_NO_2
11
ALARM_IN_2
6
ALARM_OUT_NC_2
12
ALARM_IN_1