User manual

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 14 -
QUICK INSTALLATION GUIDE: SNC-6202 and SNC-6212IR
To operate the IP dome camera, please follow these steps:
1. Install the camera in the desired location.
2. Connect the camera to power using PoE (PoE switch or PoE injector required) or
12 V DC / 24 V AC.
3. Insert the CD (included in the delivery) into your PC/laptop and install the IP-finder.
4. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn’t work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
Note:
The camera comes with a default IP address:
Default IP address: 192.168.1.168 (or by DHCP, if available)
User name: admin
Pass word: 9999
Please refer to the following chapters in this user manual for further installation information
and on camera configurations.
No.
Connector
Pin
Definition
1
RJ-45
-
10/100 Mbps Ethernet / PoE
2
Power
24 V AC
1
24 V AC
2
24 V AC
12 V DC
3
12 V DC (-), GND
4
12 V DC (+)
3
BNC
-
Analogue video-output
4
Alarm & Audio I/O
1
Alarm In (–)
2
Alarm In (+)
3
Alarm Out (–)
4
Alarm Out (+)
5
Audio Out (R)
6
Audio Out (L)
7
Audio GND
8
Audio In (R)
9
Audio In (L)
5
Micro SD card slot
-
For video recording storage
6
Reset button
-
Press your finger on the reset
button for approx. 15 sec. to
restore the camera to factory
settings.
Note on power connection:
When connecting power,
please note that the
connection pins on the 4-pin
plug are separate for 12 V
DC and 24 V DC.
Improper power connection
may lead to camera
damages and to invalidation
of warranty!
6
5
4
3
2
1