User manual

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 13 -
QUICK INSTALLATION GUIDE:
SNC-5312IR, SNC-5315IR, SNC-5323IR
ATTENTION!
Please do not open the camera housing.
All connections and settings are accessible from the outside.
The camera is equipped with a motorised DC vario lens and is adjusted via the web
interface (focus, zoom).
Improper handling will invalidate the warranty!
To operate the IP camera, please follow these steps:
1. Connect the
power/PoE/alarm/audio
cables from the ceiling or
wall to the corresponding
connectors of the camera.
Connect the camera to
power using PoE (PoE
switch or PoE injector
required) or 12 V DC / 24 V AC.
2. If required, open the lid on the bottom of the housing. Here you will find the additional
video test connector, the reset button and the micro SD card slot.
3. In the desired installation location, mount the camera using suitable screws.
4. Use the included torx wrench to loosen the bracket screws a bit to adjust the camera
into the right position. If you are satisfied with the camera position, tighten the bracket
screws again.
5. Sunshield:
Ensure to correctly install the sunshield.
6. Insert the CD (included in the delivery) into your PC/laptop and install the IP-finder.
7. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn’t work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
IP address:
The camera comes with a default IP address:
Default IP address: 192.168.1.168 (or by DHCP, if available)
User name: admin
Pass word: 9999
Please refer to the following chapters in this user manual for further installation information
and on camera configurations.