User manual

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 108 -
If the motion detection function is activated, a window (motion) with indication of motion will
be shown.
When motion is detected, the signals will be displayed on the motion window as shown
below.
Motion detection:
Users are able to turn on/off motion detection or set it “by schedule”.
If you select “by schedule”, alarm settings have to be defined according to chapter 2.3.8.
Motion detection setting:
Users can adjust the following parameters of motion detection:
Detection level [1-100]:
The default level is 10.
Here you can adjust the sensitivity regarding changes in the picture (pixel changes).
The higher the value, the non-sensitive the detection becomes, e.g. against noise.
Sensitivity level [1-100]:
The default level is 80 which means if 20% or more sampling pixels are detected
differently, the system will detect motion. The bigger the value, the more sensitive it
is. Meanwhile, when the value is bigger, the red horizontal line in the motion
indication window will be lower accordingly.
All fields sum-up to max. 100.
Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each detected motion.
Within this interval, a second motion alarm is not triggered.