User manual

User Manual
SNC-3342 / SNC-6332
_________________________________________________________________________________
- 14 -
Camera rear view:
Interface
Description
Power jack
The input power is 12 V DC, 2A.
RJ-45 LAN
socket
Connect to PC or hub/switch.
For connection to 10Base-T Ethernet or 100Base-TX fast
Ethernet cabling. Please use CAT-5 cable to connect the camera
to a 100Mbps fast Ethernet network switch or hub.
Note: Only use one power source, either from DC or from 802.3af
Power-over-Ethernet (PoE).
Micro SD card
slot
The camera has a built-in micro SD card slot which is used for
image/video event recording.
Note:
The SD card must only be ejected or inserted when the camera is
turned off.
Audio IN
Connect a microphone to the camera. Please use an active-type
microphone.
Audio OUT
Connect a loud speaker to the camera.
This is for voice alerting and 2-way audio. Please use an active-
type speaker.
GPIO
7 pin terminal block (see following table for details).