User Guide

13
800.533.7533 | Santa-Fe-Products.com Santa Fe ULTRA155/ULTRA205 Installation & Operation Instructions
This Santa Fe Dehumidier is equipped with a MERV-13 (Dimensions: 1.75” x 15.50” x 19.50”) lter. The lter
should be checked and replaced every three to six months. Operating the unit with a dirty lter will reduce
dehumidier capacity and eciency.
DO NOT operate the unit without the recommended lter. Filter non-compliance voids the product warranty.
AIR FILTRATION
Changing the Filter
For greatest ltration and eciency of the Santa Fe Dehumidier, it is recommended the air lter be
replaced every three to six months with a MERV-13 lter.
CAUTION!CAUTION!
MAKE SURE UNIT IS OFF BEFORE CHANGING THE FILTER.
Step 1: The lter door is attached to the cabinet by three hinges. Release the latch from the cabinet
by pulling it towards the front of the unit. The lter door will swing open to gain access to the lter.
Step 2: Remove the lter by gently pulling it straight out of the unit. Insert new lter by gently
pushing it straight into the unit. Make sure the AIR FLOW arrow on the lter is pointing into the unit.
Side View
Filter Door
Fresh Air Intake
(Optional)
Return
Slide Latch
Side View
Filter
Return
Filter
Supply
Return
Filter
Supply
To Remove,
pull out straight.
Side View
Filter Door
Fresh Air Intake
(Optional)
Return
Slide Latch
Filter Door Closed
Latch
Side View
Fresh Air Intake
(Optional) and
Return Air Duct
Supply Air Duct
Return
Filter
Supply
Return
Filter
Supply
To Replace,
push in straight.
Front View Front View
Filter
Door
Open
Step 3: Close the lter door by swinging it shut and reattaching the latch.
Filter
Door
Open
Side View
Filter Door
Fresh Air Intake
(Optional)
Return
Slide Latch
Filter
Door
Closed
Side View