User Guide
7
800.533.7533 | www.Santa-Fe-Products.com Santa Fe Classic Installation & Operation Instructions
Air Filtration
The Santa Fe Classic is equipped with a MERV-13 air lter (89-90% ASHRAE dust spot). An optional MERV-11 lter is available
at www.ThermastorFilters.com. The MERV-13 lter should be checked and replaced every three to six months. Operating the
unit with a dirty lter will reduce dehumidier capacity and efciency.
DO NOT operate the unit without the standard MERV-13 or optional MERV-11 lter. Filter non-compliance voids the product warranty.
Changing the Filter
For greatest ltration and efciency of the Santa Fe Classic, it is recommended that the MERV-13 lter be
replaced every three to six months
Step 1 - Remove the lter by
pulling it gently out of the unit
from the front side.
Step 2 - Insert the new lter by gently sliding
it back into place inside the unit. Be sure the
arrows on the lter are pointing down towards
the unit.
CAUTION!
MAKE SURE UNIT IS OFF BEFORE CHANGING THE FILTER. FAILURE TO FOLLOW FILTER HANDLING INSTRUCTIONS MAY
RESULT IN IMPROPER FUNCTION OF THE DEHUMIDIFIER AND CAUSE PREMATURE FILTER WEAR OR UNIT DAMAGE.
SIDE VIEW
FILTER
SIDE VIEW
FILTER
CAUTION!
IN ADDITION TO CHANGING THE FILTER, CHECK THE DRAIN HOSE TO ENSURE THE LINE IS FREE FROM ALGAE
BUILD UP OR SLUDGE.