Install Instructions

Pump Kit

Part No. 4022220

Parts Included:

1. Condensate Pump with Cord (120V)

2. (2) 8-18 x 3/4 Screws (Vertical

conguration only)

3. 3/8" x 20' Hose

4. Clamp

Tools Required:

• Phillips Screw Driver

• Level

• Utility Knife

• Additional materials will be

needed to elevate dehumidier

CAUTION!

BEFORE INSTALLING PUMP KIT, DISCONNECT DEHUMIDIFIER FROM ELECTRICAL

POWER AND DISCONNECT DRAIN HOSE IF PREVIOUSLY INSTALLED.

4201 Lien Rd Madison, WI 53704

•

TOLL-FREE 1-800-533-7533

•

www.thermastor.com

•

sales@thermastor.com

TS-201 6/20 Rev F

OVER

Vertical

conﬁguration

only

Route hose as shown

into the hole farthest

from the dehumidier.

Pump Top View

Cut hose at 45 degree angle

and attach as shown.

Horizontal & Vertical Configuration

Step 1

: Route 9/16" hose

from the dehumidifier to the

condensate pump as shown.

Be careful not to kink the

hose. Trim hose to fit properly.

To help with proper drainage,

cut hose at 45 degree angle.

PAGE 1
Pump Kit Part No. 4022220 Parts Included: 1. Condensate Pump with Cord (120V) 2. (2) 8-18 x 3/4 Screws (Vertical configuration only) 1 2 3. 3/8" x 20' Hose Vertical configuration only 4. Clamp Tools Required: • Phillips Screw Driver • Level 4 3 • Utility Knife • Additional materials will be needed to elevate dehumidifier CAUTION! BEFORE INSTALLING PUMP KIT, DISCONNECT DEHUMIDIFIER FROM ELECTRICAL POWER AND DISCONNECT DRAIN HOSE IF PREVIOUSLY INSTALLED.
PAGE 2
Step 2: Insert clamp onto 3/8" drain hose and then attach hose onto the barbed outlet fitting on the condensate pump. Tighten clamp and verify that hose is secured tightly to the condensate pump by gently pulling on the hose. Route hose appropriately to drain. Route to drain. Pump Top View Attach clamp and hose as shown. Note: Do not exceed 15 ft. vertically when pumping to a drain above the unit.