Operation Manual

16
This TV is equipped with a channel memory feature which allows channels to skip up or down to the
next channel set into memory, skipping over unwanted channels. Before selecting channels, they
must be programmed into the TV’s memory. To use this TV with an antenna, set the Tuning Band menu
option to the Air mode. When shipped from the factory, this menu option is in the Cable mode.
Air/Cable selection
1
Press SETUP/TV MENU in the TV mode. The menu screen will
appear.
2
Press ▲ or ▼ to select
“Setup” menu, then press
▶.
Setup
Audio
Feature
Picture
Tuning Band
DTV Signal
Auto Ch Search
Add On Ch Search
Manual Ch Set
Channel Labels
Menu Language
Reset
Cable
English
To M ov e
To S e l e c t
To E x i t
Enter
Menu
3
Press ▲ or ▼ to select
“Tuning Band”.
Setup
Audio
Feature
Picture
Tuning Band
DTV Signal
Auto Ch Search
Add On Ch Search
Manual Ch Set
Channel Labels
Menu Language
Reset
Cable
English
To M ov e
To S e l e c t
To E x i t
Enter
Menu
4
Press ▶ or ENTER to
select “Air” or “Cable”.
Air
- VHF/UHF channels
Cable - CABLE TV channels
Setup
Audio
Feature
Picture
Tuning Band
DTV Signal
Auto Ch Search
Add On Ch Search
Manual Ch Set
Channel Labels
Menu Language
Reset
Air
English
To M ov e
To S e l e c t
To E x i t
Enter
Menu
5
Press SETUP/TV MENU to return to the normal screen.
CABLE CHART
The chart below is typical of many cable system channel
allocations.
Memorizing channels
NOTE:
It may take a few seconds for a digital
channel picture to appear on screen
after being selected.
•
5Z90101A.indd 165Z90101A.indd 16 07.9.3 3:48:31 PM07.9.3 3:48:31 PM