Manual

Press D,-or ENTER to return your settings to the
factory settings.
Press MENU to return to the normal screen.
NOTE:
• You also can reset the settings by pressing RESET
when "Setup" menu is selected.
Picture control
adjustment in the
Component and PC mode
You can adjust to optimize the performance of
the TV in the Component and PC mode.
Example: Adjust the H-Pos in the component mode.
Press INPUT SELECT repeatedly to select the
component mode.
Press MENU during the component mode. Then
press A or T to select "Feature" menu, then press
3
4
Press A or T to select "Component Set", then
press _ or ENTER.
Press A or T to select "H-Pos",then press _ or
ENTER.
5
6
Press _1or I_
• Press A or
H=Pos:
V-Pos:
Clock:
Phase:
Auto Adjust
(PC Setting
only):
Setting:
to adjust the setting.
T to change the adjusting item.
To adjust the horizontal position of
the image on the Component or PC
mode.
To adjust the vertical position of the
image on the Component or PC
mode.
To minimize any vertical bars
or stripes visible on the screen
background.
This must be adjusted after the
frequencyof the Component or
PC mode has been set to 60Hz to
optimize picture quality (page 16).
To optimize "H-Pos', "V-Pos",
"Clock" and "Phase" automatically.
To return your settings to the factory
settings.
Press MENU to return to the normal screen.
NOTE:
If no buttons are pressed for more than approx. 30
seconds, the Menu-screen will return to normal
Monitor-screen automatically.
The "Component Set" and "PC Set" settings are not
effective for other input modes.
26