Owner`s manual

Connections to other equipment (continued)
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including
Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.
Rear of the unit
| Speaker
Subwoofer I (Right)
Fro nt r......L___ TV 1 .___LZ
_ Speaker-_----/\ (_ _ A / \
(Left) \\} _ _//L_
To DIGITAL AUDIO / I'_;_(,':_)
COAXIAL OUT (_ ,, _ _FJ-'JC--3 _-_-J
CoaxiaIdigitatcabte _ I "_
(not supplied) "1
To Coaxial I _ \ Center Speaker
Digital Audio IN (_ _ ,_,
..... ooo ) I Surround Surround
Speaker (Left) Speaker
AV Amplifier with built-in digital o (Right)
decoder as listed above
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio.
There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
To connect the TV to a PC (Personal Computer)
Before you connect this TV to your PC, change the adjustment of your PC's Resolution and
Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA
connector PC MONITOR on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case
of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the
AUDIO connector of the PC/DVI AUDIO IN jack of the TV. You can also connect the PC with HDMI cable. If you
use HDMI cable, you don't have to connect the audio cord. If you use DVI-to-HDMI cable, please connect audio
cord as same way as VGA cable.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.
Rear of the unit Monitor Display modes
_ MODE Resolution Refresh rate
°°8 @ VGA 640x480 60/72/75 Hz
@ VGA 720x400 70Hz
II G G _ _ _1_ @11 SVGA 800x600 56/60/72/75Hz
J 1 1_(.,)_j_ XGA 1024x768 60/70/75 Hz
, WXGA 1280x768 60Hz
l WXGA 1280x720 60Hz
WXGA 1360x768 60Hz
To return to normal mode
To PC/DVl Press INPUT SELECT again.
AUDIO IN
To HDMI IN
I
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
PC
ToPC
?MONITOR
VGA cable (not supplied)
Audio cord (not supplied)
HDMI cable (not supplied)
13