User Manual

3.8.4 Abnormality

When the equipment can not get the channel video signal, the video loss alarm and the linkage function will

be turned on.

Steps:

1.Go to NVR’s [Main Menu]- [Record]- [Record Configuration] to tick [Alarm].

2.Go to NVR’s [Main Menu]- [Alarm]- [Abnormality] to enter the interface of Abnormality. Click and select

[Event Type](No Storage/Storage Device Error/Storage No Device/Net Disconnection/IP Conflict can be

selected), [Enable], [Show Message], [Buzzer], [Mobile Reported], [Send Email] according to you needs,

and then click [OK] to save, as shown in the figure below.

Analyzing and inspecting current software and hardware of the device: When some abnormal events happen,

the device will make a relative answer such as show message and buzzer.

Steps:

1.Go to NVR’s [Main Menu]- [Record]- [Record Configuration] to tick [Detect].

2.Go to NVR’s [Main Menu]- [Alarm]- [Intelligent] to enter the interface of Intelligent. Click and select [Alarm

rules] to select Tripwire or Intrusion,click [Alarm linkage] to set period/Record channel/tour/snapshot and

other functions according to you need, and then click [OK] to save, as shown in the figure below.

3.8.5 Intelligent