User Manual

3.8.1 Motion Detect

Steps:

1. Go to NVR’s [Main Menu]- [Record]- [Record Configuration] to tick [Detect].

2. Go to NVR’s [Main Menu]- [Alarm]- [Motion Detect] to enter the interface of Motion Detect. Click and

check [Enable], select [Channel], [Sensitivity], [Period], [Record Channel], [Buzzer], [Send Email] according

to you needs, and then click [OK] to save, as shown in the figure below.

When the system detects that the motion signal has reached the set sensitivity level, the motion detect alarm

will be triggered and the linkage function will be turned on.

3.8.2 Video Blind

3.8.3 Video Loss

Steps:

1.Go to NVR’s [Main Menu]- [Record]- [Record Configuration] to tick [Alarm].

2.Go to NVR’s [Main Menu]-[Alarm]-[Video Blind] to enter the interface of Video Blind. Click and check

[Enable], select [Channel], [Sensitivity], [Period], [Record Channel], [Buzzer], [Send Email] according to

you needs, and then click [OK] to save, as shown in the figure below.

When the video image is influenced by the environment such as the dimlightingconditions or reaching the

setting sensitivity parameter, the camera mask function and the linkage function will be turned on.

Steps:

1.Go to NVR’s [Main Menu]- [Record]- [Record Configuration] to tick [Alarm].

2.Go to NVR’s [Main Menu]- [Alarm]- [Video Loss] to enter the interface of Video Loss. Click and check

[Enable], select [Channel], [Sensitivity], [Period], [Record Channel], [Buzzer], [Send Email] according to

you needs, and then click [OK] to save, as shown in the figure below.