User Manual

2018/08/17 14:06:39 Fr

CAM01

CAM02

CAM03

CAM04

2018/08/17 14:06:39 Fr

3.6 Playback

[Channel]: Select the corresponding channel number to set the channel.

[Redundancy]: Click and check this option to double backup the file. Every video file will be duplicated to

saved in two hard disks drive instead of one if your system supports installing two hard drives. Make sure that

there are two hard disks installed. One is read-write disk and the other is redundant disk.

[Length]: Set the time length of each video file. 60 minutes is the default value.

[PreRecord]:Record 1-30 seconds before the action. (time length is decided by the code stream)

[Record Mode]: Set video state: schedule, manual or stop.

[Period]: Set the time section of common recording. The recording starts in the set range only.

[Record Type]: Set recording type: regular, detect or alarm;

1 ) Regular: Continuous recording according to time period

2 ) Detect: Record video once motion is detected during the time perid,please use this mode for light alarm

camera.

3 ) Alarm: This is for hardware alarm

Two methods for you to playback the video files in the hard drive:

1. Right-click mouse and then select [Playback] in the menu structure on your desk.

2. Enter [Main Menu]- [Record]- [Playback].

The video has been recorded in [Regular], you can click [ ] button to playback the video files when the

channel number and the time bar turns green, as shown in the figure below.