User Manual

3.3.3 Network Test

3.3.2 Time—Language Configuration

You can enter[Setup Wizard], and click [Next] to go to this interface.

[Time Zone]: Set and select the time zone.

[System Time]: Set the system data and time.

[Date Format]: Choose the data format: YMD, MDY, DMY.

[Date Separator]: Choose list separator of the data format.

[Time Format]: Choose time format: 24-hour or 12-hour.

[Language]: Select the language you want, such as English, French, Portuguese, Russian, Italian, S-Chinese,

T-Chinese, Spanish, Thai, Greek, Japanese, German, Polish.

You can enter[Setup Wizard], and click [Next] to the next step, and then click [Next] again go to this

interface. When you connect the NVR to router by using an Ethernet Cable, if it shows [Test Gateway.......ERR],

click [Retry] to turn the network connection status into [Test Gateway......OK]. You can also click “Network”

to set up the IP address and gateway manually. If you don’t want to connect the NVR to the network, you can

click “Skip”.

Make sure [Test Gateway], [Test network], [Test DNS] are [OK], which means your device has been

connected to the network properly, and then you can view all cameras image remotely on the computer and

mobile phone.