Installation Guide

6
1
3
2
Please remove the regulator cover and regulator O-ring under the following conditions:
Caution: Must use the regulator cover and regulator O-ring when the water pressure
is greater than 15 PSI.
How to do:
1. Take out the regulator with pliers and other tools.
2. Remove the regulator cover and regulator O-ring except the sealing O-ring.
3. Insert the regulator component into the inlet pipe.
a. When the water pressure is lower than 10 PSI.
b. When the nozzle cannot work normally and water pressure is low.
Regulator
Regulator
cover
Regulator
O-ring
Sealing
O-ring
7. Wipe the hoses and connectors thoroughly with a towel and carefully observe for any leaks for at least
10 minutes. Tighten any connectors gently until leakage stops. If any leaks continue, turn off the water
supply and check older hoses for damaged rubber O-rings and replace them if necessary.
*Optional, only do the following if water pressure is too low.
Warning
1. Do not lift the product with the seat cover and seat open.
This may damage the bidet seat.
2. Do not use with hot water where temperature is higher
than 40 /104 .
1. This will not apply to most customers, however, if you happen to have a rigid water
supply line to your toilet tank you will need to replace that with a flexible steel braided
water supply hose which can be found at any hardware store, Home Depot, Lowe's etc.
The addition of the "T" connector will make an existing "rigid" hose too long. We
recommend you purchase the same length flexible hose as your rigid line +/- an inch.
It does not need to be exact because it's flexible, but too long may look unattractive.
2. There is a white rubber hose that is sealed in a plastic bag. Occasionally the rubber
gasket will fall out of the hose end during shipping. Just make sure you put it back in
place if yours fell out, or if you find it loose in the bag with the hose.
3. If you are not using the nuts, be sure to firmly push the two adapter plate anchors all
the way into the two holes on your toilet bowl to ensure the adapter plate fits tightly to
your toilet after tightening the stainless steel screws.
3
Extra Installation Tips