Installation Guide

1. Turn off the water supply valve.
2. Unscrew the water supply hose from the water
tank. Place a towel below the tank to catch any
dripping water.
3. Using finger nut, attach the T-shaped connector
to the water tank where you removed the water
supply hose.
4. Attach the water supply hose to the bottom of
the T-shaped connector.
5. If they have become loose during shipping,
press the filter screen and rubber washer into
the connectors at the ends of the white water
inlet hose. Connect the white water inlet hose to
the bidet seat and the other end to the T-shaped
connector and tighten snugly. Do not over
tighten.
6. Slowly turn on the water valve to check if
there is any water leakage.
Unscrew to remove
Finger nut
Washer
Filter
Connecting Water Inlet Hose