Specification

CONNECTIONS
TECHNICAL SPECIFICATIONS
Saniswift® Pro
APPLICATION
PUMPING DISTANCE
14 Ft
140 Ft
SINK
LAUNDRY
SHOWER
DISHWASHER
RESIDENTIAL
COMMERCIAL
Saniswift Pro • PART N
O
022
Example of installation. Follow local plumbing codes for actual install.
The Saniswift Pro drain pump is used to pump gray water away from a variety of fixtures
in residential and commercial applications. The system is able to discharge the waste
up to 14 feet vertical and/or 140 feet horizontal.
Discharges the waste through either a 1”, 1-1/4” or 1-1/2” rigid pipe. A non-return valve
is included on the discharge fitting assembly provided with the system.
Has been designed with a 1–1/2” vent connection on top of the lid. All plumbing codes
require connection to a vent system. Either inlet located on top of the housing can be
used for the vent or as an inlet. Please note that the vent system should be a two-way
air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air
admittance valves or similar devices is not permitted.
Discharges gray water from a kitchen sink, shower, dishwasher, washing machine
(indirect connection via laundry sink). The gray water will drain into the system via three
inlets, two 2” inlets (with built-in check valves) on either side of the housing and one
1–1/2” inlet on top of the enclosure.
An easy access service panel is located on top of the pump. This will provide accessibility
to the electrical components such as the capacitor, pressure switch, and electronic board
without the need to remove or disconnect the pump. For a full list of parts, please refer
to the next page.
Drain Pump
ASME A112.3.4
Discharges through 1”, 1-1/4” or 1-1/2” pipe.
Air pressure switch activated providing
a superior water detection system.
Easy access to major components.
No need to remove or disconnect.
Heavy-duty enclosure for chemical drain
resistance and designed with 2” low inlets
with built-in check valves.
CSA & IAPMO listed for nationwide compliance.