Spec Sheet

CONNECTIONS
SANIGRIND PRO • PART N
O
014
SANIGRIND
®
Pro Grinder
Example of installation. Follow local plumbing codes for actual install.
The Sanigrind Pro is a 1 HP
pump system used to install
a complete bathroom up
to 25 feet below the sewer
line, or even up to 150 feet
away from a soil stack.
It incorporates a grinder
system which is ideal for
uncontrolled environments
in both residential and
commercial applications
(ie. rental unit, offices,
warehouses, etc).
The Sanigrind Pro is
designed to handle sanitary
products that may have
been flushed down the
toilet; such may consist of
condoms, sanitary napkins,
q-tips, dental floss, etc.
Discharges the waste through a 3⁄4” or 1” rigid pipe. A non-return valve is included on the discharge
elbow assembly provided with the system. This elbow can be rotated 360 degrees depending on the
discharge installation.
Has been designed with a 1–1⁄ 2” vent connection on the top of the lid. All plumbing codes require
connection to a vent system. Please note that the vent system should be a two-way air vent as air needs
to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices
is not permitted.
This pump is designed to be connected to any conventional toilet with a bottom outlet (not supplied
by Saniflo). Note that there should be a minimum 1⁄4” per foot gravity fall on the waste pipe coming
from the toilet into the pump.
Will also discharge gray water from any sink, bath/shower, urinal and even a washing machine
(indirect connection). The wastewater will drain into the system via two 2” inlets with built-in check
valves on either side of the housing. Note that when adding a bathtub/shower, the base should be
raised up by a minimum of 8” off the floor.
An easy access service panel is located on top of the pump. This will give you easy access to the
electrical components such as the capacitor, microswitch, electronic board and membrane. For a full
list of parts, please refer to the next page.
ASME A112.3.4
USE ANY CONVENTIONAL TOILET
TO COMPLETE YOUR BATHROOM
INSTALLATION
There are no limitations when it comes to designing
your bathroom around the Sanigrind Pro (014) system
as you can select any conventional toilet of your
choice.
Mix and match your fixtures (shower, bathtub, sink)
from other brands to complete your installation.
The unit can either be installed on top of the floor
while the rest of the fixtures are installed on a raised
platform or you can lower the pump eliminating
the need to create a subfloor.
APPLICATIONS
TOILET
LAUNDRY
SINK
SHOWER
SINK
WASHING
MACHINE
BATHTUB
RESIDENTIAL
COMMERCIAL
PUMPING DISTANCE
FULL VIEW OF COMPLETE BATHROOM
CLOSE-UP VIEW OF PRODUCT
25 Ft
150 Ft
12" - 18" max.
16