Dimensions Guide

EXTERNAL UNITS - SPECIFICATION SHEET

TECHNICAL SPECIFICATIONS

The Sanigrind Pro is a 1 HP pump system used to install a complete bathroom up to 25 feet below the sewer line, or even up to

150 feet away from a soil stack. It incorporates a grinder system which is ideal for uncontrolled environments in both residential and

commercial applications (ie. rental unit, offices, warehouses, etc). The Sanigrind Pro is designed to handle sanitary products

that may have been flushed down the toilet; such may consist of condoms, sanitary napkins, q-tips, dental floss, etc.

Discharges the waste through a

⁄4" or 1" rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the

system. This elbow can be rotated 360 degrees depending on the discharge installation.

Has been designed with a 1

⁄2" vent connection on the top of the lid. All plumbing codes require connection to a vent system. Please note

that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance

valves or similar devices is not permitted.

This pump is designed to be connected to any conventional toilet with a bottom outlet (not supplied by Saniflo). Note that there should be a

minimum

⁄4" per foot gravity fall on the waste pipe coming from the toilet into the pump.

Will also discharge gray water from any sink, bath/shower, urinal and even a washing machine (indirect connection).

The wastewater will drain into the system via two 2" inlets with built-in check valves on either side of the housing.

Note that when adding a bathtub/shower, the base should be raised up by a minimum of 8" off the floor.

An easy access service panel is located on top of the pump. This will give you easy access to the electrical

components such as the capacitor, microswitch, electronic board and membrane. For a full list of parts,

please refer to the next page.

FULL VIEW OF COMPLETE BATHROOM

CLOSE-UP VIEW OF PRODUCT

Pump type: Grinder

Electrical: 120 V – 60 Hz / 9 Amps (Max)

Motor: 1 HP oil-filled thermally protected motor

Capacitor rating: 60 microfarad

Operating Temperature: 104 F° (110 F° Max.)

Power cord length: 49 inches

Noise level: ≤ 63 dBA (Lp) (measured at 3 ft.)

SANIGRIND PRO • Part No. 014

Grinder

PAGE 1
Grinder FULL VIEW OF COMPLETE BATHROOM EXTERNAL UNITS - SPECIFICATION SHEET © SFA Saniflo Inc. CLOSE-UP VIEW OF PRODUCT © SFA Saniflo Inc. The Sanigrind Pro is a 1 HP pump system used to install a complete bathroom up to 25 feet below the sewer line, or even up to 150 feet away from a soil stack. It incorporates a grinder system which is ideal for uncontrolled environments in both residential and commercial applications (ie. rental unit, offices, warehouses, etc).
PAGE 2
ECLATE GRIND PRO US 2015 06.10.pdf 1 10/14/15 1:08 PM Discharge pipe diameter: 3⁄4" or 1" Discharge rate at 25 ft: 19 GPM 60 21d 28a 29 28a 66 28c 67 28a Discharge rate at 3 ft: 38 GPM Shut-off head: 38 ft. 28b Normal running time: Depends of toilet system 31 Capacity: 3.2 gallons Inlets: 2" (sides), 1 ⁄2" vent (top) 1 Method of activation: Membrane/microswitch Shower/bathtub base height: 8" min Weight: 30 lbs.