Spec Sheet

CONNECTIONS
SANISHOWER • PART N
O
010
Example of installation. Follow local plumbing codes for actual install.
The Sanishower drain pump is used to pump gray water away from a variety of fixtures in residential
applications. The system is able to discharge the waste up to 12 feet vertical and/or 100 feet horizontal.
Discharges the waste through a 3/4” or 1” rigid pipe. A non-return valve is included on the discharge
fitting assembly provided with the system. Unlike the other models, the discharge for this model is on
the side of the enclosure.
Has been designed to be vented through a 1–1/4” or 1–1/2” pipe. The vent output is located on the
top of the pump. The case has a knockout which along with the rubber adapter provided is used to
connect to the vent pipe. Note: The use of mechanical vents, air admittance valves or similar devices
is not permitted.
Discharges gray water from a shower or sink. The gray water will drain into the system
via two 2” inlets (with built-in check valves) on either side of the housing.
SANISHOWER Drain Pump
APPLICATION
RESIDENTIAL
SINK
SHOWER
ø 3/4” or 1” discharge
ø 2” Drain
5”
PUMPING DISTANCE
AN EASY SOLUTION FOR
A REMOTE SHOWER OR
SINK INSTALLATION OR
FOR ANY GRAY WATER
APPLICATION
Easy to install and small enough to
fit underneath a shower base. Ideal
for medium duty applications.
Pre-assembled system with a low
inlet and built-in check valve. Typical
installations include the discharge of
gray water from showers, sinks and
pedicure chairs.
12 Ft
100 Ft
38