Dimensions Guide

SANISHOWER • PART NO. 010
DRAIN PUMPS - SPECIFICATION SHEET
© SFA Sanifl o Inc.
TECHNICAL SPECIFICATIONS
The Sanishower drain pump is used to pump gray water away from a variety of fixtures in residential applications.
The system is able to discharge the waste up to 12 feet vertical and/or 100 feet horizontal.
Discharges the waste through a ¾" or 1" rigid pipe. A non-return valve is included on the discharge fitting assembly provided with the
system. Unlike the other models, the discharge for this model is on the side of the enclosure.
Has been designed to be vented through a 1¼" or 1½" pipe. The vent output is located on the side of the pump. The side of the case
has a knockout which along with the rubber adapter provided is used to connect to the vent pipe. Note: The use of mechanical vents, air
admittance valves or similar devices is not permitted.
Discharges gray water from a shower or sink. The gray water will drain into the system via the 1 ½" side inlet (with built-in check valve)
located on the side of the enclosure.
Pump type: Drain pump
Electrical: 120 V – 60 Hz / 5.5 Amps (Max)
Motor: 0.2 HP oil-filled thermally protected motor
Capacitor rating: 25 microfarad
Operating Temperature: 104 F° (110 F° Max.)
Power cord length: 48 1/2 inches
Noise level: ≤ 44 dBA (Lp) (measured at 3 ft.)