4 3 POWER SLEEP 5 DISPLAY STANDNY TIME SET APS MONO/STEREO 6 19 LOCK FM / MW / LW MEMO PRESET HOUR TUNING - MIN 18 27 PRESET STATION LW/MW/FM STEREO SYNTHESIZEO RECEIVER PR-D1 21 22 11 12 B C D E A Music Volume 6V-DC 9 10 7 8 News Normal 13 14 15 16 17 ON OFF CLOCK AUTO ADJUST 1 RDS -ALARMRDS Z Z Z 20 G H AM PM Mhz Khz M 1 J K 2 3 L 4 5 6 7 8 9 M 1
1 Clock auto adjust on/off set to on position, while radio power is on , receiving FM band stations with RDS CT (clock time) signal , the clock can be auto adjusted . Set to off position , the clock can be adjusted manually .
Display Symbol A Stereo mode B Alarm mode (Radio or Buzzer) C RDS station D Sleep (Radio auto shut off) status E Snooze F AM & PM for 12 hours clock (Optional) G Clock H Lock operation I Low battery indicator J Display frequency , station name and others K Memory L Station preset M Khz or Mhz Power Supply The set can be operated by -Four 1.5v batteries (IEC 46 or UM 3 or AA size) -DC 6V power adaptor to connect to 6V DC jack Connector plug ,6 mm dia ,negative pole inside Insert four 1.
Time set For the first time to operate this radio ,display will show "--:--" after you installed the batteries . Press TIME SET button 14 display will show TIME SET and clock flashes'0:00' or 'AM 12:00'. Press HOUR adjustment button 13 and MINUTE adjustment button 18 to set the time Press TIME SET button again to finalize the time setting ,The clock will start from 0 second.
You may select to be awaken by your favorite radio station. Tune the the desired station, press MEMO button12 , then STANDBY button 11 display will show STANDBY, before STANDBY disappears, press MEMO button again to complete the setting and tum off the radio, display will show current time and STANDBY ,if you like to see the alarm time, press STANDBY button,display will show alarmed time and alarm station.
The tuning increments are : FM :50 kHz MW: 9 kHz LW : 1 kHz Storing stations (Memory) For each of the 3 wave bands, 9 transmitting stations can be stored via MEMO button 12 and PRESET + - button 13 . A total 27 presets can be used. Tune in the desired station as described above, then press MEMO button 12 for memory, display will show SAVE M1 to suggest you to store the station on PRESET 1 (you may select your PRESET No.
If receiving the station without RDS signal, display will only show frequency. If receiving FM station with RDS CT (clock time) and CLOCK AUTO ADJUST switch 1 set to AUTO position, the radio will adjust the time automatically according to the RDS station CT signal.(If the switch set to off position, can not adjust the time automatically).
