Owner manual

FM Radio

Operating your radio in FM mode

Carefully extend the telescopic aerial and press the Standby button to switch on your radio.

Press the Radio button as needed to select FM radio mode.

Press the Tuning Up button (on the radio) or the Tunning Up button (on the remote control) and

then the Auto button on the remote control. The displayed frequency will increase. Your radio

will scan up the FM band from the currently displayed frequency and will stop scanning when it

nds a station of sufcient strength.

The display will show the frequency of the signal which has been found. If RDS information

is available, after a few seconds the display will show the radio station name. If you only hear

hiss or interference, simply press the Auto button to scan further. Your radio may have found a

spurious interference signal.

To find more FM stations press the Auto button (on the remote control) to repeat the scan

operation. To scan down in frequency, press the Tunning Down button (on the radio) or the

Tunning Down button (on the remote control) and then the Auto button. Your radio will scan

down the FM band from the currently displayed frequency and will stop scanning when it nds

a signal of sufcient strength.

Alternatively press and hold the Tunning Up on the radio to scan up in frequency or the

Tunning Down button to scan down the FM band.

When the end of the waveband is reached your radio will recommence tuning from the

opposite end of the waveband. Use the Volume buttons to adjust the sound level as needed.