Owner manual

WPA and WPA2 are similar, although WPA2 offers a higher level of security. Whichever

you selected in step 7, you then have to specify the variant used. They are TKIP (Temporal

Key Integrity Protocol) and AES (Advanced Encryption Standard). As previously, the setting

should match that used by your router. Some routers allow both to be specified, and the

router will use whichever variant is supported by the connected device. AES is regarded as

the more secure option if it is available.

The radio will then require you to enter the encryption key. This must be a string of between 8

and 63 characters and must be identical to the key which has been entered into your router.

Note – the encryption key is sensitive to the use of upper and lower case letters and

symbols. Take care to enter the key exactly, or the radio will not be able to connect to your

router. The three controls on the right-hand side of the screen have special functions. You

can quickly access these by pressing the Info button and then use the Folder Up or Down

and Select buttons as needed:

select ‘ ’ to erase a character just entered (long press to clear); Info again to continue

select ‘ ’ when the complete encryption key has been entered

select ‘ ’ to cancel and go back to the TKIP / AES options screen

Once the key is entered the radio should connect to the network.

While the radio is trying to connect to the network, it will display ‘Processing…’ when

checking the encryption key (if using the WiFi connection) and then ‘Connecting…’. If the

connection is made successfully, the radio will return to the Network settings menu. If the

unit cannot connect, then it will display a ‘Failed to connect’ message and will return to the

SSID entry screen (step 6).Once connected, the network settings are stored in the radio. The

settings are retained whenthe radio is disconnected from the mains. You may now use the

Back and Radio or Media buttons to access the functions of your radio.

10.

11.

The three controls on the right-hand side of the screen have special functions. You can

quickly access these by pressing the Info button and then use the MenuUp or Down and

Select buttons as needed:

select ‘ ’ to erase a character just entered (long press to clear); Info again to continue

select ‘ ’ when the complete encryption key has been entered

select ‘ ’ to cancel and go back to the SSID settings screen

Once the key is entered the radio should connect to your network. Please skip to step 11.